Cisco 7921 not updating standard time
After 2-3 minutes, the software installs and a message appears on the task bar stating "Found New Hardware - Software installed and ready to use." Step 8 Click Finish when the installation is complete.
The phone briefly displays "USB Connected" on the status line. Step 2 Locate and double-click the new LAN connection to open the Local Area Connection Status window, then click Properties.
For more information, see the "Backup Settings for Phone Configuration" section.
Step 6 Reset the phone from Cisco Unified Call Manager to disable full access to the web pages.
Be sure to change the Web Access privileges and reset the phone to prevent users from making configuration changes on the phone web pages.
Note If a wireless IP phone was previously registered to Cisco Unified Call Manager Release 4.x, and then registers to Cisco Unified Call Manager 5.x, the Phone Configuration web page password might be reset to "Cisco." Related Topics •Accessing the Phone Web Page •Configuring Network Profiles •Configuring USB Settings •Configuring Trace Settings •Using System Settings You can configure up to four different profiles for a phone to take advantage of different WLAN environments.
Table 4-2 describes these items and provides references for more information.
To display Network Profile(1-4) Settings, access the web page for the phone as described in the "Accessing the Phone Web Page" section, and then click the Profile (1-4) hyperlink.
Search for cisco 7921 not updating standard time:
Related Topics •Installing the USB Drivers •Configuring the USB LAN on the PC •Using the USB Cable to Configure Phones •Accessing the Phone Web Page You might have to update settings on a Cisco Unified Wireless IP Phone 7921G that is already configured and in use.